Maxflow® Power Cooler®Installation Instructions1996 - 1998 Ford 4.6 Mustang Cobra (4 Valve)P/N: 8N301-040 CARB EO #D-213-15This product may no
A. Remove battery tray and notch to allow tank to sit flush with bottom of tray and reinstall (see photo - 3).B. Place the water tank in the tray pre
Plumbing Schematic© 1999 VORTECH ENGINEERING, INC.All Rights Reserved, Intl. Copr. Secured6FRONT OF VEHICLEWATERTANKRETURN WATER FROMAFTERCOOLER COREW
A. Remove the air dam from the lower radiator core support.B. Loosely attach the supplied water cooler brackets to the cooler using the supplied 1/4&q
A. Connect the wiring harness to the water pump. Attach a 16 GA eyelet to the brown wire (negative) and route to a clean ground free from paint and v
A. Check all fittings, hose and clamps for tightnessand leaks. Make sure all wires and lines are properly secure with clamps or tie wraps.B. Make sur
NOTE(Read before installation is started)Included in this kit is a smaller than originally supplied supercharger pulley. This new pulleyis recommende
Installation InstructionsVortech Maxflow Power CoolerCongratulations on selecting the best performing and mostefficient aftercooler today... the Vort
WARRANTY/REPAIR PROCEDUREFORCEPOWER® PARTS Basic Limited WarrantyVortech Forecepower parts carry a ninety (90) Day LIMITED WARRANTY from the date of p
Part No. 8N301-040Vortech Maxflow Power Cooler1996 - 1998 Ford 4.6 Mustang Cobra (4 Valve)IMPORTANT: Before beginning installation, verify that all p
A. Remove strut tower brace from the vehicle.B. Disconnect and remove the battery (if locatedin the factory position, the battery will need tobe reloc
A. Loosen and remove the six (6) 1/4-20 cap screws and retaining plates that hold the compressor housing to the gearcase.B. Carefully rotate the super
3. Aftercooler and Discharge Tube MountingA. Install the bypass valve onto the 1” cooler inletbarb using the original hose. Secure the assembly to th
4. Idle Air Control and Valve Cover Vent LinesA. Using the 3/4” 90° elbow slide the shortest end onto the 3/4” barb of the 3-1/2” x 45° inletelbow and
Commentaires sur ces manuels